>
> So far I've done as little as possible in inittab (syslog, getty, mounts)
>> + s6-svscan starts all other stuff.
>>
>
> You can run your gettys and syslogd under s6 too. :)
>
>
One of the reasons I think I need s6-rc is a race between starting logger
and starting the services that need logging. I need to be sure I get every
log produced and the example logging service from s6 looks awesome.
Does the logging from s6-linux-init setup in stage1 work the same way as
the example from s6? Does it use s6-log?
Do I need to have a separate logging service if one was already created in
stage1?
>
> s6-svscan doesn't run with PID 1. It's started in inittab.
>>
>
> This doesn't change anything, s6-rc will work with that setup too.
Awesome
>
> So can I setup s6-rc + initd and later use s6-linux-init? Would that add
>> any work compared to doing both at the same time?
>>
>
> No, those are completely independent steps. However, if you intend
> to replace sysvinit at some point, you will need to migrate the services
> that are currently supervised by it into services supervised by s6
> (and possibly managed by s6-rc).
>
>
This simplifies my work a lot, thanks!
Received on Thu Feb 25 2016 - 15:03:37 UTC
This archive was generated by hypermail 2.3.0
: Sun May 09 2021 - 19:44:19 UTC